Receive instant hot water with this gas water heater at a rate of 10 litres per minute. Heat water 25 degrees above ambient temperature at the full 10LPM (higher temperatures can be achieved with smaller flow rates). A simple design with automatic ignition means the heater is activated when the tap is turned on and switches off when the tap is turned off - without using a pilot light. Built-in safety features include a flame failure device and low water pressure cut out.
This appliance must be installed by a registered gasfitter in accordance with AS/NZS 5601 and NZS 5428
Dimensions (H x W x D) : 636 x 350 x 238mm (top vent excluded)
1/2'' threaded water inlet and outlets
1/2'' threaded gas inlet (hosetail with rubber washer supplied)
Recommended pressure: 35-55PSI
Recommended flow: 10-15LPM
Steel housing, white enamel finish
LCD temperature display
Ignition uses 2 x D cell batteries (sold separately) so no external power required (designed for use with Panasonic alkaline batteries)
Achieves 25 degrees increase at 10 lpm (or higher at lower flow rates)
Automatic ignition - no pilot light (starts when tap is turned on, stops when tap is turned off)
Flame failure (gas shuts off if flame goes out)
Low water pressure cut out
Gas hose and regulator not included
Please note this unit is not designed for use on boats or inside motorhomes/caravans. We recommend discussion with your gasfitter regarding the mounting location to ensure ventilation requirements will be met before purchase
THIS UNIT MUST BE VENTED EXTERNALLY AND INSTALLED BY A REGISTERED GASFITTER IN ACCORDANCE WITH AS/NZS 5601 and NZS 5428
$5.99 standard freight rate for non-rural, shoe box sized deliveries. Additional charges apply for rural delivery, island delivery, dangerous goods and large packages.