*Terms and conditions apply
Galvanised Short Link DIN766 Anchor Chain Grade 30
UPC
m24431
Grade 30 or grade 40? What working/breaking load per size?
Question by: Joachim GIMENEZ on 15/10/2021, 12:01 pm
Hi Joachim
Burnsco galvanised short link chain (m24431) - 6,7,8 & 10mm are all Grade 40 or DIN 766 grade high tensile chain
Regards
Burnsco Webstore
Burnsco galvanised short link chain (m24431) - 6,7,8 & 10mm are all Grade 40 or DIN 766 grade high tensile chain
Regards
Burnsco Webstore
Answer by: Website Customer Service (GC) on 5/11/2021, 2:47 pm
Answer The Question
How long should my 6mm galvanized anchor chain last before rust starts showing ? I have a 30' keel boat and the anchor gets used regularly while cruising in Feb and March, and sits in the anchor well the rest of the time,
Question by: Gun Caundle on 13/11/2021, 8:32 am
Galv chain wear can vary greatly depending on usage and conditions. Generally a manufacturing fault will crop up very soon after initial use. Otherwise use of a winch gypsy and/or rocky mooring grounds can increase chain wear. If the chain is less than 2 years old please send us pictures to website@burnsco.co.nz and we will investigate further.
Answer by: Website Customer Service (AL) on 15/11/2021, 4:50 pm
Answer The Question
Where is your chain made?
Question by: Julian on 23/11/2021, 9:48 pm
This is good quality chain made to Burnsco specs in China/Taiwan
Answer by: Website Customer Service (AL) on 24/11/2021, 8:54 am
Answer The Question
Hi, will the 6mm chain function correctly with the Maxwell HRC6-FF windlass? Seems you don’t sell the 6mm version, only the 7mm which I’m guessing again is for US 1/4” chain likely called 7mm here?
Question by: Ryan Daniel on 22/11/2023, 7:32 pm
Yes -
Use short link chain: 6mm (HRC6), 7mm (HRC7), 8mm (HRC8)
•Use nylon rope (3 strand or multi-plait): 12mm (HRC6 and 7), 14mm (HRC8)
Use short link chain: 6mm (HRC6), 7mm (HRC7), 8mm (HRC8)
•Use nylon rope (3 strand or multi-plait): 12mm (HRC6 and 7), 14mm (HRC8)
Answer by: Website Customer Service (WE) (Admin) on 23/11/2023, 8:16 am